Butterfly Valve manufacturing company
Knowledge Center
 Home >

Knowledge Center

> Selection Guide for Globe Valve

Selection Guide for Globe Valve

  • 2021-05-04 10:10

        The stem axis of the globe valve is perpendicular to the sealing surface of the valve seat. The opening or closing stroke of the valve stem is relatively short, and it has a very reliable cut-off action, making this valve very suitable for the cut-off or adjustment and throttling of the medium. Once the valve disc of the shut-off valve is in the open condition, there is no longer contact between its valve seat and the sealing surface of the valve disc, and has a very reliable cut-off action. This kind of valve is very suitable for cutting or regulating and reducing the medium. Stream usage.

        Once the stop valve is in the open state, there is no contact between its seat and the sealing surface of the disc, so its sealing surface is less mechanically worn, because most of the valve seats and discs are easier to repair or replace It is not necessary to remove the entire valve from the pipeline when sealing the components, which is very suitable for the occasions where the valve and the pipeline are welded together. The flow direction of the medium through this type of valve has changed, so the flow resistance of the stop valve is higher than that of other valves.

 

        Commonly used shut-off valves are as follows:

        1) Angle type shut-off valve; in the angle type shut-off valve, the fluid only needs to change its direction once, so that the pressure drop through this valve is smaller than that of the conventional structure of the shut-off valve.

        2) Direct-flow stop valve; in direct-flow or Y-shaped stop valve, the flow passage of the valve body is in a diagonal line with the main flow passage, so that the damage degree of the flow state is smaller than that of the conventional stop valve, so the pressure loss through the valve is also corresponding Is too small.

        3) Plunger type globe valve: This type of globe valve is a variation of the conventional globe valve. In this valve, the disc and valve seat are usually designed based on the plunger principle. The valve clack is polished so that the plunger and the valve stem are connected, and the sealing is achieved by two elastic sealing rings sleeved on the plunger. The two elastic sealing rings are separated by a collar, and the sealing ring around the plunger is pressed firmly by the load exerted on the bonnet by the bonnet nut. The elastic sealing ring can be replaced and can be made of various materials. The valve is mainly used for "open" or "close", but it is equipped with a special form of plunger or a special collar, which can also be used to adjust the flow .

Copyright! 2021 Tianjin Jiangrui Fluid Equipement Co.,Ltd.All Rights Reserved. Powered by WILLIAM

IPv6 network supported

IPv6 network supported Google Anylitics Console

contact

Send A Message

Send A Message

    If you are interested in our valves and want to know more details,please leave a message here,we will reply you as soon as we can.

  • supplier
  • contact
  • email